pmzuloo.blogg.se - Network booster verizon

#Network booster verizon download

Make sure your phone has Advanced Calling or HD Voice activated.Once the LTE Network Extender is in service, your phone must be within 50 feet, horizontally, of the unit.To verify your Verizon Wireless phone is connected to the LTE Network Extender Making Calls Using Your LTE Network Extender Press the display button to see additional information about your Network Extender. After successful startup, the indicator will return to o and the display will show “Service Active…”. NOTE: If an error message appears on the LCD display, or if Startup takes longer than an hour, please refer to the Startup Troubleshooting table in this QSG.

This will typically take 5-60 minutes, depending on GPS signal conditions. When it does, startup and self-configuration will begin. The LTE Network Extender will turn on automatically

Plug the Power Adapter into an available outlet.Ĥ.

Plug the power supply connector into the 12V DC power port located at the rear of the LTE Network Extender.

Plug one end of the provided Ethernet cable into an available LAN port on your router and the other end to the LAN port on your LTE Network Extender.

NOTE: Optional wall mount brackets are sold separately on.

The Verizon LTE Network Extender can be placed on a flat surface, such as a table or shelf, or mounted to the wall.

Your Network Extender needs to be plugged into a power outlet.

Place your Verizon LTE Network Extender at least 10 feet away from products that generate electromagnetic radiation (e.g., a microwave oven).

NOTE: A GPS signal is necessary for the Verizon LTE Network Extender to work properly and to provide your location if you dial 911 in an emergency. See the GPS Troubleshooting section for instructions.

For better GPS signal strength, please pull out and unwrap the GPS extension cable stored at the back of the Network Extender to position the GPS antenna as close to a window as possible. For best results, place your Verizon LTE Network Extender near a window where a strong GPS signal can be acquired.Position Your Verizon LTE Network Extender Consider these factors when choosing a location for your Verizon LTE Network Extender: GPS signal: The Network Extender requires a continuous GPS signal from the provided GPS antenna.Ģ.A Router/Modem: The Verizon LTE Network Extender must be connected to an available LAN port on a router or modem with always-on internet access.NOTE: Home satellite broadband access is not supported.

#Network booster verizon download

Internet Access: High speed wired broadband with minimum download speed of 10 Mbps and upload speed of 5 Mbps, 20 Mbps down and 10 Mbps up or higher is recommended.

Review these Verizon LTE Network Extender Requirements Press the Reset button for 10 seconds for factory reset.ġ.

Press to toggle display options to show device information.

Please see GPS Troubleshooting section in this QSG for more information. If the LCD Display shows “GPS Insucient Error”, open the bottom cover and remove the GPS module stowed in the compartment.

To provide the device with good GPS signal, place the device near a window that’s without any metal shielding.

Depending on device mode, the LED may either show white or red.